Ready to order! -Djas Puhr, Labria, Nikto, Tessek, and Barada

[Son Of Dengar]

That Djas Puhr sculpt is fantastic by the way.

 

[AceRimmer]

Hey guys, any update on the measurements?

 

[TaliBane]

Hey guys, any update on the measurements?

I spent about 20-30mins with these calculating and I'm pretty sure they are spot-on for 1/6, but others can weigh in.

I've just done the one dimension because I figured that's all you need to scale the whole thing and also the vertical height is trickier to make clear due to the detailing. Basically, this is both heads measured at the widest point.

FYI the same dimension on Klaatu/Wooolf in-hand/currently is about 44mm. So overall the correct size would be a little over 18% bigger than the sizing that was previously uploaded to Shapeways (that created the too-small head.)

 

[TaliBane]

Dimensions matched.

 

[AceRimmer]

Ok, since nobody else commented I take those m3asirements are good. I'll try to get them scaled in the next few days. Recovery takes longer than I had optimistically anticipated, I was tole to take it slow...

 

[TaliBane]

Ok, since nobody else commented I take those m3asirements are good. I'll try to get them scaled in the next few days. Recovery takes longer than I had optimistically anticipated, I was tole to take it slow...

Sent you a PM.

 

[Chakaman]

To me, that Klaatu sculpt still looks a bit small.

 

[TaliBane]

To me, that Klaatu sculpt still looks a bit small.

Yeah, if you're referring to it, the measurements matched pic above is just showing the two heads as if they were physically next to each other, illustrating that the printed one is too small.

If you print out or resize the 51/52mm (51 is correct) dimension in the print pic above, that is the size I think it needs to be.