TD-Old Rust sculpt by Trevor

Custom One-Sixth Figures Forum

Help Support Custom One-Sixth Figures Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I made a few more of the cigs today, they take longer than you might think.

$8 each shipped worldwide, [email protected]
Please make sure your info is all in the receipt/notes.

Remember, if you ordered a painted mug, you are getting one free, please don't try to pay for yours.

Thanks
 
Payment just sent for an international shipped headsculpt.

Rdeezy: would you be so kind to share the recipe for the outfit on that completed figure? Thanks!
 
Payment just sent for an international shipped headsculpt.

Rdeezy: would you be so kind to share the recipe for the outfit on that completed figure? Thanks!
This is the shirt I used bleached white then dyed and buttons replaced also cut off the shoulder straps.
5e4caa54edbd180a81ab484b7159d9ab.jpg


Used these pants.
0f98b54fe951c9df828f9861f87c08a5.jpg


Used this for the undershirt.
ad15cb52e02ec26b20e5281a7f929e2f.jpg


Boots were Threezero Zombie boots
 
This is the shirt I used bleached white then dyed and buttons replaced also cut off the shoulder straps.
.....

Many thanks for that list, Rdeezy! I forgot to ask...which body did you use? The sculpt is not neckless but you need to see his arms, so the only option that I've found so far is this one by ZC:

HTB1RYmfHXXXXXbqXXXXq6xXFXXXg.jpg

But Rust is quite skinny, and I'm thinking that those arms may be too muscular for him.
 
Many thanks for that list, Rdeezy! I forgot to ask...which body did you use? The sculpt is not neckless but you need to see his arms, so the only option that I've found so far is this one by ZC:

View attachment 217749

But Rust is quite skinny, and I'm thinking that those arms may be too muscular for him.
The body used was the HT Robocop Alex Murphy body.
 
I initially made the using a foil backed paper but, they could easily be bent if handled too much. These are made with a lot stronger metal that can be bent but, not as easily. If there is any interest I sell these for $10.00 for a set of 3. First class shipping is free in the U.S. I mail these flat in an envelope to keep the shipping to a minimum so you will need to make the bend for the feet. If interested send me a PM. Turn around is usually about two days.

 
Back
Top